“Smart” meters are wildly inaccurate: Study finds that readings can be 581% too high

via govtslaves.info

… The electromagnetic fields (EMFs) emitted by these devices have been linked to a variety of health problems, including headaches, fatigue, digestive issues and sleeping problems. There is also evidence that EMFs cause more serious conditions like autoimmune disorders and certain types of cancer. And, as if that wasn’t enough reason to refuse to have one of these devices in your home, research has found that they aren’t even accurate! Not only do they put your family’s health at risk, but they may be ripping you off financially at the same time.

As reported by Natural Health 365, a study published in the journal IEEE Electromagnetic Compatibility Magazine, conducted by researchers from the University of Twente and the Amsterdam University of Applied Sciences, found that some smart meters give readings far higher than the actual amount of energy consumed. In fact, some of these meter readings were over 580 percent higher than they should have been. …

To conduct the study, lead researcher Franz Leferink, Professor of Electromagnetic Compatibility at the UT, tested nine different electronic meters manufactured between 2004 and 2014. The meters were connected via electric switchboard to various power-saving devices – including energy-saving light bulbs, heaters, LED bulbs and dimmers. The team then compared actual energy consumption with the readings furnished by the electronic meters.

The results were profoundly disturbing. Five of the nine meters – more than half – gave readings higher than the actual power consumed – in some cases, a staggering 582 percent higher. Other readings were 475 percent, 566 percent, 569 percent and 581 percent higher than actual use. (This could theoretically reflect a near six-fold increase in a utility bill – a rip-off of outrageous proportions!)

Interestingly, of the remaining four meter types, two were accurate and only two billed less (32 percent) than the actual electricity consumed. The odds are overwhelming high, therefore, that you are more likely to get stuck with overbilling than underbilling.

Why the difference?

The researchers discovered that there is a design flaw in some meters which causes the elevated readings. Meters containing a “Rogowski coil” current sensor delivered faulty readings when used in combination with modern, energy-efficient switching devices like dimmers, LEDs and energy-saving lightbulbs. The reason for this is that when these modern devices are used, the electricity produces an erratic rather than a perfect waveform, which these types of meters have not been designed to read.

The meters associated with the lower readings in the study were those that used a “Hall effect-based” current sensor. (Related: ‘Smart’ meters threaten privacy, health and basic human rights.)

Unfortunately, all these types of meters are certified and meet legal requirements, which means you have to know exactly what you’re getting if you do decide to ignore the health risks and choose to install a smart meter in your home….

https://www.naturalnews.com/2018-10-17-smart-meters-are-wildly-inaccurate.html

Switching power supplies all by themselves seem to be a real problem from a health perspective.   They cause discontinuities in the input circuit amperage which result in high frequency emissions for which the indoor power wires act as antennas into the home.   That’s one kind of RF emission from smart meters because they have built-in switching supplies.   The other RF emission comes from the built-in peer-to-peer mesh networking transmitter, which is constantly chatting with your neighbors’ meters to relay their data to other meters.   The network as a whole discovers the nearest utility receiver, which could be miles away, and funnels all the data to it.   Saves money for the utility (fewer receivers needed) but results in thousands of times more transmissions than required to report your own data.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.